- 6 black steel 1 5/8 7 1/2 ft finished height fence support posts
- 6 caps for posts
- 6 no-dig ground sleeves for posts
- 6 locking set screws for ground sleeves (makes posts removable or permanent)
- 9 black steel 1 3/8 89" framing posts
- 1 7 1/2ft x 100ft roll of Critterfence Steel Grid 1" opening square black PVC coated galvanized steel
- 1 driving anvil for post sleeves
- 2 8" 120lb breaking strength black fence ties 100pk
- 1 12" kinked galvanized ground stakes 30pk
- 4 1 3/8 to 1 3/8 black clamp hardware
- 10 1 5/8 to 1 3/8 black clamp hardware
- 2 1 5/8 to 1 3/8 black center clamp hardware
- 72 black self tapping screws
- 1 fence instructions
Installed kit dimensions:
7 1/2 feet wide by 15 feet long, 112.5 square feet
7 1/2 feet tall outside and 7 feet inside overhead clearance. This kit includes 7 1/2 foot tall posts and 7 1/2 foot tall fencing. If you want additional fencing overlapped and staked to the ground to cover changes in grade, you can either 1) cut the support posts 6" to gain 6" of overlap or 2) add a small roll of fencing along the bottom (2 foot by 150 rolls are available separately for example). If you decide to add fencing, use a hogringer hand tool with hogrings (available separately) to make the seam.
Add-on kits are available separately to expand to the side and to the rear.
Access gates/doors are add ons and separate. The matching height for a gate/door is 7 feet tall, the gate will install under the framing for the top.
Posts are round galvanized inside and out then black powder coated - no-dig sleeves are heavily galvanized inside and out for extreme long life - ground sleeves go into the ground 30", the finished height of the fence posts is the height above ground (for example, 7.5ft finished height is 7 1/2 feet above the ground once the sleeve is in the ground and the post has been installed into the sleeve).
All posts with ground sleeves can be installed permanently or made removable. No dig ground sleeves get driven into the ground with a sledge hammer (available here on our website if needed: sledge hammer), posts then slide inside the sleeve. To remove posts for seasonal protection or to move your fence: 1) cut fence ties holding fence to posts 2) roll up fencing 3) slide post up out of sleeve. To make posts permanent, use the galvanized locking sleeve spikes included with each kit to prevent the post from spinning or coming up out of the post (instructions provided with each kit). Ground sleeve caps to cover ground sleeves when no posts are installed are also available here on our website: ground sleeve caps
For rocky or heavily compacted ground, we suggest using a san angelo digging bar to pilot the hole for sleeves (instructions with kit). They are available here on our website if needed: san angelo digging bar. You can also use a powered drill or hammer drill with our sleeve auger bit found here: sleeve auger
These fence kits are designed to be installed on level and flat areas. If you're installing this over an area that has slope or is pitched in one direction, some cutting or modifying of the fence post height will be required. This may make the overall height of your fence shorter. For example, if you are installing in an area that slopes higher to lower, to make the enclosure level, you would cut the front posts 1" for example, the middle posts 1/2" for example and leave the rear posts.
These fence kits start with approximately 7 feet of overhead clearance. The side posts are 7 1/2 feet out of the ground but some space is needed for the framing and side bracing. Access gates are available separately; select 7 foot tall gates or shorter for proper installed clearance.